Samsung SL-M4080FX Service Manual page 149

•
Diagnostics > Adjustment > Copy Adjustment > Image Position
Purpose
Operation Procedure
Copyright© 1995-2013 SAMSUNG. All rights reserved.
Manually adjust copied image position on paper in copy engine
NOTE
Before copy adjustment,
1) Please make sure that initial values of margin adjustment must be the same as values of
print adjustment.
2) It is recommended to perform adjustment for each tray at a time. i.e. do not select "All" for
tray selection. It often causes confusing for the adjustment.
3) The Procedure for copy adjustment is almost same as "Print Adjustment".
NOTE
-
Adjustment must be done for each tray (tray1, tray2, tray3, tray4, MP).
-
It is recommended not to choose "ALL" for tray selection.
- It is always better to adjust for a particular tray at each time.
- Adjustment range : ± 5.0 mm
1) Select a tray required adjustment.
2) Change the adjustment value with "+", "-" then press "OK" button to save changes.
• Simplex Leading Edge
• Simplex Side Edge
• Duplex Leading Edge
• Duplex Side Edge
3) Print out the test pattern and check if the image is moved as you want. If not, repeat stpe2.
4. Troubleshooting
4-52