Preparing To Connect The Cisco Isa 3000 - Cisco ISA3000-4C-K9 Hardware Installation Manual

Connecting the ISA 3000
This chapter describes how to connect the Cisco ISA 3000 Industrial Security Appliance to Ethernet
devices and a network. The chapter contains the following sections:
•
•
•
•
•

Preparing to Connect the Cisco ISA 3000

Before you connect the Cisco ISA 3000 to the devices, install the ISA 3000 according to the instructions
in Chapter 2, "Installing the Cisco ISA 3000 Industrial Security
Caution
If this product will be installed in a hazardous location, read the Getting Started/Printed Document of
Compliance included in the package.
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to
Warning
telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports
contain TNV circuits. Some LAN and WAN ports both use RJ-45 connectors. Use caution when
connecting cables. Statement 1021
Preventing Damage to the Cisco ISA 3000
Before installation, observe these general guidelines:
•
•
•
Preparing to Connect the Cisco ISA 3000, page 3-33
Connecting a PC to the ISA 3000 For Configuration, page 3-34
Connecting to DC Power, page 3-35
Verifying Connections, page 3-39
Connecting Alarm Circuits, page 3-40
Proper ESD protection should be observed
Ensure the device is properly grounded
Ensure there is proper airflow around the device
Cisco ISA 3000 Industrial Security Appliance Hardware Installation Guide
3
C H A P T E R
Appliance".
3-33