Neurotech AvivaTens XP Instructions For Use & Warranty page 16

12. Continue to increase the intensity of the channel until the desired level has been
achieved. Where more than one channel is being used, you may increase the
intensity completely from one channel before increasing the intensity from the other.
Display 5 shows the screen during a contraction cycle during an open treatment
time program. The timer displays hours and minutes, and is counting up.
13. Once the desired intensity level is reached, the user can press the Lock button to
prevent accidental changes in intensity. To do so, press the Lock button once. The
lock icon (
simply press the lock button once again and the lock icon disappears from the display.
14. If you want to interrupt the treatment session (e.g. to reposition the electrodes),
briefly press the on/off button. The unit issues a beep and the pause icon appears
on the display in order to signal that the program has been paused (Display 7). To
deactivate the pause function, press the on/off button again. Then the treatment
session is restarted from where it was paused and the pause icon disappears from
the display.
15. The Burst mode can be used during Programs 2 and 3. Pushing the button enables
Burst mode. To deactivate the function, press the button again (Display 8).
The Trigger mode can be used during Programs 1, 4, and 5. When the Trigger
button is pressed while in program 1, the signal frequency increases from 4Hz to
99Hz. Press the Trigger button a second time to disable Trigger mode. When the
Trigger button is pressed once during program 4 or 5, Trigger mode is enabled.
When the button is pressed a second time the unit enters a contraction cycle
which lasts as long as the button remains pressed. When the button is released
11
) will appear on the display (Display 6). To disable the Lock function,
Display 5
Display 6
Lock button
Display 8
activated.
Display 7
Pause activated
Display 8