Keypad Settings For Partitioned Systems - Ranger 9000E Installation Manual

Location 660: Call Back Optional Features
The number programmed in location 660 will set the callback options for the control panel. Any or all of the features
below can be obtained by programming the appropriate data in this location. The correct data can be obtained by
ADDING the values of the corresponding characteristics from the table below (possible values are 0 to 7).
VALUE
1
2
4
Example 1 - Programming a "5" (1 + 4 = 5) in this location will combine the characteristics for values 1 and 4.
Example 2 - Programming a "7" (1 + 2 + 4 = 7) in this location will combine all of the characteristics described.
Location 661: Local Programming Lockout
Location 661 is used to disable local programming lockout. If a "5" is programmed in this location, all local
programming is locked out. If an "A" is programmed in this location, all programming functions related to the digital
communicator will be locked out. Any other number in location 661 will allow all local programming.
Location 662: Control Panel Shutdown
Location 662 is used to shutdown the control panel. Programming an "A" in this location will completely shutdown
the control panel. The keypad will appear "dead" with only the "Trouble" LED illuminated, and the siren and
communicator will not operate. WARNING: EXTREME CARE SHOULD BE TAKEN NOT TO INADVERTENTLY
PROGRAM THIS LOCATION.
The keypads used with the Ranger 9000E control panel have a 4-position dip switch on the PC board that is easily
accessed from the back of the keypad. If partitioning is not being used, all switches must be in the "OFF" position.
If partitioning is being used, refer to the table below to set the keypads for use in the correct partition.
PARTITION NUMBER
PARTITION #1
PARTITION #2
PARTITION #3
PARTITION #4
The positions of dip switches 1 and 2 determine the partition to which the keypad belongs, as indicated in the table
above. For example, if the keypad is in Partition 3, Switch 1 should be "OFF", and Switch 2 should be "ON".
Switches 3 & 4 are reserved for future use, and should be in the "OFF" position at all times. All keypads are shipped
from the factory for Partition 1 usage (switches 1 & 2 "OFF"). NOTE: These keypads will not function properly if the
correct partition is not selected.
Panel will automatically callback for download session.
Site initiated download call by entering [ r ]-[9]-[8]-[#] at keypad,
and/or automatic callback if a "1" is programmed in location 622.
Panel will automatically callback when the event log is full.

KEYPAD SETTINGS FOR PARTITIONED SYSTEMS

CHARACTERISTIC
SWITCH 1
OFF
ON
OFF
ON
37
SWITCH 2
OFF
OFF
ON
ON