Locations Accessible Thru Downloading Only - Ranger 9000E Installation Manual

Location 631: Programming The Current Year - Ones Digit
Location 631 contains the current year - ones digit. If the current year is 1996, this location should contain a "6",
which is the ones digit of the current year. If the current year is 1997, this location should contain a "7", which is the
ones digit of the current year.
Location 632: Programming The Current Hour - Tens Digit
Location 632 contains the current hour - tens digit. The time is entered in 24 hour time. If the current time is 5:25 PM,
the 24 hour time is 17:25, so this location should contain a "1", which is the current hour - tens digit. If the current
time is 9:36 AM, the 24 hour time is 09:36, so this location should contain a "0".
Location 633: Programming The Current Hour - Ones Digit
Location 633 contains the current hour - ones digit. The time is entered in 24 hour time. If the current time is 5:25
PM, the 24 hour time is 17:25, so this location should contain a "7", which is the current hour - ones digit. If the
current time is 9:36 AM, the 24 hour time is 09:36, and this location should contain a "9".
Location 634: Programming The Current Minutes - Tens Digit
Location 634 contains the current minutes - tens digit. The time is entered in 24 hour time. If the current time is 5:25
PM, the 24 hour time is 17:25, so location 160 should contain a "2", which is the current minutes - tens digit. If the
current time is 9:36 AM, the 24 hour time is 09:36, and this location should contain a "3".
Location 635: Programming The Current Minutes - Ones Digit
Location 635 contains the current minutes - ones digit. The time is entered in 24 hour time. If the current time is 5:25
PM, the 24 hour time is 17:25, so this location should contain a "5", which is the current minutes - ones digit. If the
current time is 9:36 AM, the 24 hour time is 09:36, and this location should contain a "6".
THE FOLLOWING LOCATIONS ARE ACCESSIBLE ONLY THROUGH DOWNLOADING
Locations 636-643: Control Panel Access Code
Locations 636-643 contain the eight digit access code the 9000E must receive from the downloading software
before the panel will permit downloading to occur. The factory default code is listed in the instructions provided with
the CADDX download software package.
Locations 644-659: Call Back Telephone Number
If a telephone number is programmed into these locations, and "callback" is enabled in location 660, the control
panel will hang up for approximately 36 seconds (insuring that the calling party has disconnected), and then call
back. If tone dialing is desired, program an "F" in the location where tone dialing should begin. If the entire number
should be tone dialing, program an "F" in location 644. Four second delays can be obtained anywhere in the
sequence by programming a "D" in the appropriate delay location. WARNING: THE CALLBACK PHONE NUMBER
SHOULD ALWAYS BE REVIEWED FOR ACCURACY BEFORE DISCONNECTING.
36