Assigning User Code Authority - CADDX NetworX NX-8 User Manual

ASSIGNING USER CODE AUTHORITY LEVELS
Assign authority levels to users by following the steps below. Assign user codes
before assigning authority levels.
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
LIGHT
1
2
3
4
5
6
7
8
Press the
Press the
Enter a "Master Arm/Disarm Code".
NOTE: Someone changing the authority of another
person
authorization for partitions to which they have
access.
The ready light will flash.
Enter the 2 digit "user number'' to be assigned
authority (The ready light is solid and the instant light
will flash).
Lights
assigned to this code. An explanation of the lights is
listed below. You may toggle (turn on/off) the authority
level by pressing the number for that authority level.
AUTHORITY LEVELS IF LIGHT 8 IS OFF
Reserved
(Note: Do not change if on.)
Arm Only
Arm Only After Close Window
Master Arm/Disarm (can program other codes)
Arm/Disarm
Bypass Zones
Open / Close Reporting
If this light is on, this code is programmed as a
function code. Do not change, Press [#) - [#) to exit.
key.
[*]
key.
[6]
can only add
illuminated indicate
12
or remove partition
the authority levels