Service Menu - CADDX NetworX NX-8 User Manual

SERVICE MENU

The service light will be "on" if the security system requires service.
service light is "on", press the
service condition. One or more zone lights will illuminate indicating what service(s)
is required. Call your service provider immediately for these problems. Below is
a listing of what each light means in a service condition.
LIGHT
1
SYSTEM FAULT - Press the [1] key. The zone light(s) that is
illuminated corresponds to the system fault(s) below:
Note: Faults 1 & 2 are global in nature and will affect all partitions
of a multi-partition system. Press the [#] key to return to the 1 of 8
service /iahts.
2
ZONE TAMPER - Press the [2] key and the zone light(s) will illuminate
showing the zone(s) that are tampered. Press the [#] key to return to
the 1 of 8 service Hahts.
3
ZONE LOW BATTERY - Press the [3] key. The zone light(s) will
illuminate showing which zone(s) has a low battery. This only applies
to wireless zones. Press the [#] key to return to the 1 of 8 service
/iahts.
4
ZONE LOSS OF SUPERVISION - Press the [4] key and the zone
light(s) will illuminate showing which zone(s) has loss of supervision.
This only applies to wireless zones. Press [#] key to return to the 1 of
8 service liahts.
5
ZONE TROUBLE - Press the [5] key and the zone light(s) will illuminate
showing which zone(s) has a trouble condition. Press the f#l kev to
return to the 1 of 8 service liahts.
6
TELEPHONE LINE TROUBLE/LINE CUT - This light will illuminate
when there is telephone line trouble or the telephone line has been
cut. The service light will remain lit until the telephone trouble clears
and a user code is entered. Note: This fault is global
will affect all oartitions of a multi-oartition svstem.
7
FAILURE TO COMMUNICATE -This light will illuminate when there is
a failure to communicate between your system and the central station.
Note: This fault is global in nature and will affect all oartitions of
a multi-oartition svstem.
8
LOSS OF SYSTEM TIME - This light will illuminate when there has been
a loss of power and your system clock needs to be reset. Instructions
are on page 14. Note: This fault is global
all oartitions of a multi-partition system.
To exit the Service Light Mode - press the
[*l
1 Over Current Fault
2 Siren Trouble
3 BoxTamper
4 Expander Power
key followed by the
PROBLEM
[#]
key.
7
key to determine
[2]
5 Expander Low Battery
6 Expander Box Tamper
7 Expander Trouble
8 Ground Fault
in
in
nature and will affect
If the
the
nature and