Disarming The System; Bypassing; Group Bypass - CADDX NetworX NX-8 User Manual

DISARMING THE SYSTEM

When you enter the protected area through one of the designated Entry/Exit
doors, the keypad control will sound a solid tone for the duration of the entry delay
time, or until you enter a valid code. After entering a valid code, the red armed
light will go off and the tone will stop. The security system is now DISARMED. If
a valid code is not entered before the end of the entry delay, an alarm will occur.
(NOTE: If the red armed light is flashing during the entry delay, the alarm
system has been activated in your absence. Leave the building immediately
and call your alarm company and/or the police from a safe location.)
CANCEL/ ABORT FEATURE (Optional, if programmed. See page 1.)
The cancel light will flash during an abort delay time. If a code is entered followed
by the [CANCEL] key while this light is flashing, all abortable reports will stop the
communication process. Entering a code followed by the [CANCEL] key during or
after an alarm report to the central station will cause the cancel light to come on.
It will stay on until the central station has received the cancel report.
BYPASSING ZONES
If you wish to bypass one or more zones, this must be done while the system is
in the disarmed state. The following steps are used for bypassing zones:
Step 1 Press the [BYPASS] key.
Step 2 If required (optional), enter user code.
Step 3 The bypass light flashes.
Step 4 Enter 1 or 2 digits indicating the zone you wish to bypass. (Example:
Press the (1] key for zone 1, press
Step 5 Press the (BYPASS] key again.
Step 6 The corresponding zone light will illuminate indicating the zone has
been bypassed. Repeat steps 4 and 5 for any other zone(s) that
need to be bypassed.
Step 7 Press the [BYPASS] key again -or- press the [#] key to exit the Bypass
Mode. The bypass light will stop flashing upon exiting the Bypass
Mode.

GROUP BYPASS

By pressing the [BYPASS] key, followed by the
again, all zones that are designated as group bypass zones will be bypassed.
Press the [BYPASS] key again to exit group bypassing.
(1] - [2]
key, then the [BYPASS] key
[OJ
10
for zone 12.)