Unbypassing; Turning The Door Chime On And Off; Changing Codes - CADDX NetworX NX-8 User Manual

UNBYPASSING

To manually unbypass zones, perform the bypassing procedure on a zone that is
already bypassed. The corresponding light for that zone will go off when
unbypassed. NOTE: All zones will automatically be unbypassed each time
the system is disarmed.

TURNING THE DOOR CHIME ON AND OFF

The door chime is turned on or off by pressing the [CHIME] key while the system
is in the disarmed state. If the chime is on the
the chime is off, the
toggle the chime feature on/off and produce a momentary ding-dong sound.
CHANGING USER CODES
Step 1 Your system must be in the Disarmed state to change user codes.
Step 2 Press the
Step 3 Press the
Step 4 Enter a "Master Arm/Disarm Code".
NOTE: For partitioned systems, someone changing the code of
another person must have access to all or more partitions than
the user being changed.
Step 5 The
Step 6 Enter the 2 digit "user number" (always enter 2 digit such as [OJ -
for user 3, or
Step 7 Enter the new four (4) or six (6) digit "user code". Note: To delete a user
code, enter
[*H*l
Step 8 The
the code is rejected, the sounder will beep 3 times.
Step 9 If another "user code" needs to be programmed, return to Step 6.
Step 10 Press the [#] key while the
Code Programming Mode.
chime light
[*l key.
key.
[5]
will flash.
ready light
[5] - [2]
[*H*H*H*l
for a 6-digit code.
will flash indicating you are back at Step 5 above. If
ready light
chime light
will be off. Each press of the [CHIME] key will
for user 52).
for a 4-digit code, or
ready light
11
will be illuminated. If
[*H*H*H*l-
is flashing to exit the
[3]
User