Using The Quick Arm - CADDX NetworX NX-8 User Manual

Step 3 • Press the
• The stay light will illuminate indicating that all interior zones
are bypassed. (All interior devices will bypass automatically,
giving the user freedom of movement within the interior
area.)
• The bypass light will illuminate if any zone(s) are bypassed.
If any zone(s) have been bypassed previously by the user,
the light(s) corresponding to the bypassed zone(s) will
illuminate, alerting the user that a zone(s) may be
unprotected and can be faulted without an alarm.
Step 4 • To change entry/exit to "Instant", press the
again.
• The instant light will illuminate indicating that the entry/exit
doors have no delay.
USING THE QUICK ARM (Optional, if programmed. See page 1.)
The Quick Arm feature may be used if it is enabled. Quick Arm will allow the user
to arm the security system in the AWAY mode by pressing the
system can be quick armed in the STAY mode by pressing the
feature is used for ARMING ONLY, and will not disarm the security system. This
is ideal for a maid or baby sitter code, etc.
Step 1 Pressing the
Entry/Exit doors and turn on/off (toggle) the instant light.
Step 2 Press the
designated interior zones.
Step 3 When armed, pressing the
enabling you to leave the building.
The instant light needs to be off at this time if you plan on re-entering the
building, otherwise you will create an alarm. You may re-Initiate an entry/exit
delay by pressing the [STAY] key again. The stay light will go out.
key.
[STAY]
Changing Modes While System is Armed
key will turn on/off (toggle) a delay on
[STAY]
key at this time to turn on/off (toggle) all
[BYPASS]
IMPORTANT
key will start the Exit delay,
[EXIT]
9
key
[STAY]
key. The
[EXIT]
key. This
A
[ST Y]