Group 35: Motor Temp Meas - ABB ACS320 User Manual



Group 35: Motor temp meas

Code Description
3501 SENSOR TYPE
Activates the motor temperature measurement function and selects the sensor type.
See also parameter
0 = NONE – Function is inactive.
1 = 1 x PT100 – Function is active. The temperature is measured with one Pt100
sensor. Analog output AO feeds constant current through the sensor. The sensor
resistance increases as the motor temperature rises, as does the voltage over the
sensor. The temperature measurement function reads the voltage through analog
input AI1/2 and converts it to degrees centigrade.
2 = 2 x PT100 – Function is active. The temperature is measured using two Pt100
sensors. See selection 1 x PT100 above.
3 = 3 x PT100 – Function is active. The temperature is measured using three Pt100
sensors. See selection 1 x PT100 above.
4 = PTC – Function is active. The
temperature is supervised using one
PTC sensor. Analog output AO feeds
constant current through the sensor. The
resistance of the sensor increases
sharply as the motor temperature rises
over the PTC reference temperature
(Tref), as does the voltage over the
resistor. The temperature measurement
function reads the voltage through
analog input AI1/2 and converts it into
ohms. The figure on the right-hand side
shows typical PTC sensor resistance
values as a function of the motor
operating temperature.
Temperature
Normal
Excessive
5 = THERM (0) – Function is active. The motor temperature is monitored using a PTC
sensor (see selection PTC) connected to a drive through a normally closed
thermistor relay connected to a digital input. 0 = motor overtemperature.
6 = THERM (1) – Function is active. The motor temperature is monitored using a PTC
sensor (see selection PTC) connected to a drive through a normally open
thermistor relay connected to a digital input. 1 = motor overtemperature.
See the figures in section
Group 35: Motor temp meas
Range
0...6
Group 15: Analogue
Resistance
0 ... 1.5 kohm
> 4 kohm
Motor temperature measurement through the standard
Actual signals and parameters 217
Resolution
1
outputs.
Ohm
4000
1330
550
100
Default S
0
T
I/O.