Yamaha DM2000 Service Manual page 42

DM2000
4. Rear Assembly U
(Time required: About 15 minutes)
4-1. Remove the SP2000. (See procedure 1.)
4-2. Remove the MB2000. (See procedure 2.)
4-3. Fasten the control panel assembly. (See procedure 3.)
4-4. Remove the two (2) screws marked [60D] and the
seven (7) screws marked [60E]. (Fig.2)
4-5. Lift the rear assembly U from the rear side and fasten
them by the two (2) rear stays. (There are two ways
of using the rear stays shown in the photo 4 or 5.)
Control panel assembly
Front stay
Photo.3
<Left side view>
[60D]
Side panel L
[60]: Bind Head Tapping Screw-B
42
<Rear view>
<Top view>
[60A]
<Front view>
Rear assembly U
Rear stay
Photo.4
A4.0X8 MFZN2BL (VC688800)
Fig.2
Photo.5
[60E] x 7
Rear assembly U
<Right side view>
[60C] x 7
[60D]
Control panel assembly
[60A]
[60B] x 8
Bottom assembly
Side panel R