DM2000
INSTALLING I/O CARDS
This section explains how to install I/O Cards.
1 Turn off the DM2000.
2 Undo the two fixing screws and remove the slot
cover, as shown below.
Keep the cover and fixing screws in a safe place for future use.
3 Insert the card between the guide rails and slide it
all the way into the slot, as shown below. You may
have to push firmly to plug the card into the inter-
nal connector.
4 Secure the card using the attached thumbscrews.
Do not leave them loose, as the card will not be
grounded correctly, which may cause the DM2000
to malfunction.
You can check which I/O Cards are installed on the Word
Clock Select page
58