Conair HTC 30 User Manual page 45

I n s t a l l i n g t h e C H H o p p e r D o o r,
U p p e r a n d L i d S e c t i o n s
H o p p e r U p p e r S e c t i o n ( s )
To install the hopper upper section(s) of the CH Hopper:
1
Apply sealer around the lip on the top of the hopper door section.
2
Using a forklift, hoist or crane, lift the hopper upper section assembly
above the hopper door section.
CAUTION: To prevent accident and injury, lift the hopper upper section onto the
hopper door section using a forklift, hoist or crane.
IMPORTANT: Line up the sight glasses of the hopper upper section(s) with the sight
glasses of the hopper door section.
3
Set the hopper upper section on the hopper door section. As the hopper
upper section is positioned on the hopper door section, make sure the holes in
the upper section align with the holes in the door section.
NOTE: If more than one (1) hopper upper section is to be installed, repeat the steps
detailed in this section for each hopper upper section.
4
Secure the hopper upper section to the hopper door section using the
supplied hardware.
(continued)
( I f A p p l i c a b l e )
TIP: Conair recommends applying
strip and stick sealer 1/8 inches
{3.2 mm} from the inside to the
edge of the CH Hopper.
NOTE: When applying the sealer,
do not cover the holes in the hop-
per door section lip. Apply the
sealer around the holes so you will
have a good seal but not interfere
with the mounting hardware that
will be used to secure the hopper
upper section to the hopper door
section.
(continued) I n s t a l l a t i o n - G e n e r a l l 3 - 1 5