Configuring The Polycom Cx7000 System Software - Polycom CX7000 series Administrator's Manual

Configuring the Polycom CX7000 System Software

Polycom, Inc.
Note that, to use this option, the Preferences > Hide Shut Down
Option from users setting must be disabled.
After turning the power off in this way, wait at least 15 seconds before you
unplug the system from its power source.
When you power on the Polycom CX7000 system for the first time, the setup
wizard runs automatically to help you configure the required settings. After
you run the setup wizard, administrators can view or change the system's
configuration.
Power the system on. The setup wizard runs automatically.
1
Choose the language to use.
2
Configure the settings on the Location screen.
3
Setting Description
Time Format Specifies your format preference for the time display.
Time Zone Specifies the time zone for this location.
Power Frequency Specifies the power line frequency for your system. In most
cases, the system defaults to the correct power line
frequency, based on the video standard used in the country
where the system is located. This setting allows you to adapt
the system in areas where the power line frequency does not
match the video standard used. You may need to change this
setting to avoid flicker from the fluorescent lights in your
conference room.
Keyboard Layout Specifies the language layout of the keyboard attached to the
system.
Configure the settings on the Network screen.
4
Setting
Obtain an IP address
automatically
Use the Following IP
Address
IP Address
Subnet Mask
Default Gateway
Administrator's Guide for Polycom CX7000 Systems
Description
Specifies that the system gets an IP address automatically.
Specifies that the IP address is not assigned automatically.
Specifies the IP address to use for this system.
Specifies the subnet mask for this system.
Specifies the gateway IP address to use If the system does
not automatically obtain one.
5