Fujitsu PRIMERGY CX2550 M4 Operating Manual page 40

Important information
Wear a suitable grounding cable that connects you to the external chassis
●
of the server.
Always hold ESD modules at the edges or at the points marked green (touch
●
points).
Do not touch any connectors or conduction paths on an ESD module.
●
Place all the components on a pad which is free of electrostatic charge.
●
I
For a detailed description of how to handle ESD modules, see the
relevant European or international standards (EN 61340-5-1,
ANSI/ESD S20.20).
Transporting the server
V
CAUTION!
Only transport the server in its original packaging or in packaging that
protects it from impacts and jolts.
In Japan and APAC, transporting the server in its original packaging does
not apply.
Do not unpack the server until it is at its installation location.
If you need to lift or transport the server, ask other people to help you.
Never lift or carry the server by the handles or the Quick Release Levers
(QRLs) on the front panel.
Notes on installing the server in the rack
V
CAUTION!
For safety reasons, at least 2 people are required to install the server
●
in the rack because of its weight and size.
(For the reader in Japan, please refer to " 安全上のご注意 ".)
Never lift the server into the rack using the QRLs (Quick Release
●
Levers) on the front panel.
When connecting and disconnecting cables, observe the relevant
●
instructions in the "Important Information" chapter of the technical
manual for the corresponding rack. The technical manual is supplied
with the corresponding rack.
When installing the rack, make sure that the anti-tilt mechanism is
●
correctly fitted.
40 Operating Manual
CX2550/60/70 M4