Advertisement
Recommended:
■
A time-delay fuse or time-delay circuit breaker.
■
A separate circuit serving only this microwave oven.
GROUNDING INSTRUCTIONS
■
For all cord connected appliances:
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
WARNING:
Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
SAVE THESE INSTRUCTIONS
Microwave Oven Preparation
1. Unplug microwave oven before proceeding with installation.
2. Remove any loose items inside microwave oven.
Bottom Duct and Upper Duct Assembly
1. Fasten bottom bracket to bottom duct using four 1/2" screws.
(Rear view of bottom duct)
A
B
A. Bottom bracket
B. 1/2" screws (4)
2. Install rear duct to bottom duct with one 1/2" screw, as shown
in inset diagram below.
3. Remove 1 existing screw from right side of microwave oven.
4. Install bottom duct assembly using four 1/2" screws on back
of microwave oven, and two 1/2" screws on bottom of
microwave oven.
5. Fasten bottom duct with 1 existing screw on right side of
microwave oven.
(Front view of microwave oven)
D
A. 1/2" screw (1) to attach rear duct to bottom duct
B. 1/2" screws (4) to install bottom duct assembly from rear of
microwave oven
C. Existing screw (1) to fasten bottom duct to microwave oven
D. 1/2" screws (2) to install bottom duct assembly from
bottom of microwave oven
Upper Duct Assembly
NOTE: Remove any dirt or oil on microwave oven surface before
ducts are attached.
1. Remove 2 existing screws from back of microwave oven.
2. Peel off backing of double-sided tape.
3. Align the upper duct screw holes to the existing screw holes
on back of microwave oven, and attach the upper duct to the
microwave oven.
4. Press down firmly on upper duct, then fasten with existing
screws.
A
A. Existing screw (2)
A
B
C
3
Advertisement
