Advertisement
4. Removing and inserting the battery
Hold the tool firmly and press the battery release button to remove the battery.
ATTENTION:
Never short-circuit the battery.
Inserting the battery
Insert the battery until it clicks into place. Make sure the poles are facing the right way
Charging
Before using the tool, charge the battery as follows: Connect the cable of the charger to a
socket (AC).
Inserting the battery into the charger
Insert the battery firmly, as shown in here until it touches the bottom of the charging
compartment.
ATTENTION:
If the battery is inserted incorrectly, it will not only not be charged, it may also damage the
charger (e.g. by bending the terminals/short-circuiting).
Charging
When you insert a battery into the charger, the battery is charged
and the charging light.
When the battery is fully charged, the charging indicator shows 100% and a beep.
Remove the battery immediately and disconnect the charger from the mains.
Phone: +49 (0)2191 8418-0, Fax: +49 (0)2191 8418-840, sales@haupa.com • Errors and technical changes reserved.
Attention!
Please remove the battery during transport and after
usage – because of avoiding deep discharge!
Germany: HAUPA GmbH & Co. KG, Königstraße 165-169, D - 42853 Remscheid.
english
... convincing solutions
Advertisement
