Advertisement
3. Notes regarding correct use
Before you start work, all active, thus current-carrying elements in the area around the
assembler must be switched to without power. If this is not possible, protective procedures for
working in the vicinity of components under current must be implemented. The charge status
of the battery should be checked before you start work
3.1.
Operating the device
First, the bolt is removed and the bar opened. The connection material is place centrally
between the 4 pressing spikes.
Caution
If the pressing is not centred, this may result in damage to the pressing head!
Then the pressing head is fully closed up again. The actuation of the operating switch triggers
the pressing procedure which is characterised by the meeting of the pressing spikes. A pres-
sing procedure is completed when the pressing spikes have been joined and the device swit-
ches over to idle.
The return of the piston is carried out manually after the maximum operating excess pressure
is reached. Then a further pressing procedure can be carried out or the bar can be opened
and the connection material removed from the pressing head.
Before reaching into the pressing head, remove the battery to ensure that the device is not
activated accidentally.
Pressing the reset button brings the pressing spikes back to the starting position in the event
of faults or an emergency.
The pressing procedure can be interrupted at any time by releasing the operating switch.
3.2.
Explanation of the areas of application
The pressing tool has pressing spikes that use force to compress copper and aluminium con-
nection materials without the need to change tools.
Advertisement
