Table of Contents
Advertisement
|
TMA1 controller > IR learning
15
You can check if the command has been
correctly learnt, if you select Test IR command
(you can use the cursor keys on the front panel
to navigate). Check if the unit you want to
control acts as expected.
Finally Name the command so you can clearly
identify it when you include it in a Macro
command sequence.
Please note: to select a letter use either the
number keys of your AV32R DP's remote control
or select a letter using the cursor up/down keys -
you can use the front panel buttons too.
1. Some IR transmission protocols need a certain number of repeats for a code to be accepted. Usually this is three times, the default for
this property. If a learnt command does not work when using Test IR Command try more or fewer Repeats
Advertisement
Table of Contents
