2. Slip the element off the wire mesh
guide.
3. Wash
the
element gently, but
thoroughly, in solvent.
4. Squeeze excess solvent out of element
and dry.
5. Pour a small quantity of 30W. motor oil
onto
cleaner
element
and
work
thoroughly into the porous foam
material.
Element must be damp with
oil but not dripping.
6. Re-insert the wire mesh cleaner ele-
ment guide into the element.
7. Coat the upper and lower edges of the
cleaner element with lube grease. (This
will provide an air-tight seal between
the cleaner case cover and cleaner seat.)
8. Re-install the element assembly, case
cover and seat.
N O T E : - - - - - - - - - - - -
Each time cleaner element maintenance
is performed, check the air inlet to the
cleaner case for obstructions.
Check
the air cleaner joint rubber to the car-
buretor and manifold fittings for an air-
tight seal. Tighten all fittings thoroughly
to avoid the possibility of unfiltered air
entering the engine.
CAUTION:----------
Never operate the engine with the air
cleaner element removed,
This will allow unfiltered air to enter,
causing rapid wear and possible
engine damage, Additionally, opera-
tion without the cleaner element will
affect carburetor jetting with subse-
quent poor performance and possible
engine overheating.
-37-