Paradyne FrameSaver DSL 9783 Installation Manual page 9

Completing Setup of the Unit From the NOC
Procedure
1. Access the remote FrameSaver unit on the TS Management Link that was set up
at the remote site.
2. Ping the FrameSaver unit five times within five seconds. The unit automatically
provisions the TS Access VC.
3. Configure specific frame relay options, including the Data Port Frame Relay LMI
settings, and any other configuration options requiring input or changes from the
default settings.
4. Set the SNMP Traps configuration options (see Configuring SNMP Trap Managers
and Traps on page 13).
5. Verify the entire path from the remote unit to the NOC NMS is functioning (see
Verifying the End-to-End Path on page 13).
6. Verify that data is being received (see Checking That Data is Being Received on
page 15).
7. Using the OpenLane VC Provisioning Application or Telnet, create all customer
VCs. This requires creation of the DLCI on the user data port, an internal DLCI, the
VPI/VCI on the DSL interface, specifying all parameters (CIR, Be, Bc), and cross
connecting the VPI/VCIs on the network interface to the DLCIs on the V.35 port.
8. Verify that all PVCs, including Management PVCs, are configured; and to see
whether the PVC is active or not (see Checking PVC Connections on page 15).
The FrameSaver installation is complete.
In the User's Guide, see Operation and Maintenance for additional status information,
and Troubleshooting for additional troubleshooting information.
9