Paradyne FrameSaver DSL 9783 Installation Manual page 8

2. Enter the Node IP Address and Node Subnet Mask.
3. Select Create a Dedicated Network Management Link, and enter a DLCI, VPI, and
VCI at the ensuing prompts. The Management Link that is created will be used by
the NOC to access the unit.
4. If the Ethernet port will be used, select the Ethernet Port Options Screen. Enable
the interface. Respond Yes to the prompt Would you like to set the
Node's Default IP Destination to Ethernet? and configure the
following:
– Enter the IP address and subnet mask for the Ethernet interface.
– Enter the Default Gateway Address (the IP Address that will be used for packets
without a route).
– Press the ESC key to return to the Easy Install screen.
5. The Network 1 FRF.8 Encapsulation Mode default setting is Translation.
Encapsulation Translation used for carrying multiple upper layer user protocols
(frame relay PVC and ATM PVC).
Modify to Transparent to use SLV and multiplexed PVC functions.
6. Save the configuration.
7. Install the network cable (see Connecting to the Network on page 10).
8. Optionally, install the Ethernet cable (see Connecting to the Ethernet on page 11).
9. Install the DTE cable (see Connecting to the DTE (Router or FRAD) on page 12).
Physical installation of the unit is complete; the NOC can now remotely access the unit
for additional configuration.
8