Installing The Switch; Included Parts - HP J9979A Installation And Getting Started Manual

Installing the Switch

The HP 1820 Switches are easy to install. They come with an accessory kit
that includes the brackets for mounting the switches in a standard 19-inch
telco rack, in an equipment cabinet, and with rubber feet that can be attached
so the switches can be securely located on a horizontal surface. The brackets
are designed to allow mounting of the switches in a variety of locations and
orientations. This chapter shows how to install the switches.

Included Parts

The following components ship with an HP 1820 Switch:
Documentation kit
■
• Quick Setup Guide
• Safety and Regulatory information
• Software License, Warranty, and Support information
Accessory kits:
■
1820-8G and 1820-8G-PoE+ Switch
Kit number 5066-2232
• two rack mounting brackets
• eight 8-mm M4 screws to attach the
mounting brackets to the switch
• four 5/8-inch number 12-24 screws to
attach the switch to a rack
• four rubber feet
Kit number 5066-0621
• three 3/4" (20-mm M4) screws for wall
and under-table mounting
• three wall anchors
• cable tie for power cord
2
2-1