Table of Contents
Advertisement
OPERATION
Preparation For Printing
4.
Place the paper on the paper feed
table.
~
Make sure every sheet in the stack is set
evenly. This helps prevent paper skewing.
CJ Make sure the leading edge of the staok
is in full contact with the front board.
0
500 sheets of paper can be loaded at a
time. If you load more than 500 sheets,
paper may not be fed properly.
~
Do not stack paper over the paper feed
side plates.
5.
Lift the feed roller pressure lever.
Caution: Be careful not to catch your finger
between the /ever and the side
paneL
6.
Make
sure
that the paper feed side
plates contact the paper gently.
O
The paper feed side plates should be
parallel to the sides of the paper stack,
othenvise the paper might not be fed
correctly.
Printing on thick and small paper
r
I
Set the side pads before adjusting the
paper feed side plates to match the
paper size.
Thick and small paper:
Heavier than
150 g/mz, 39.9 lb
Smaller than
210 x 150 mm,
8.3"
X
5.9"
l-m-
11
LI -
J
,L3
II
II I
16
.. ..
Advertisement
Table of Contents
