B&B Electronics EIR618 Series Quick Start Manual

Quick Start Guide
Elinx Managed Ethernet Switch
EIR618 Series
1
Items Included
Ethernet Switch
o
Console Cable (RS-232 RJ-45 to DB-9)
o
CD with Support Manual
o
This Quick Start Guide
o
Panel Mount Bracket
o
2
Default Settings
IP Address: 192.168.16.1
o
Subnet Mask: 255.255.255.0
o
Gateway: 192.168.16.254
o
User Name: root, Password: root
o
3
LED Chart
LED Status
Green The Switch is powered on
PWR
Off The Switch is powered off
Green Power Source 1 is available
PWR1
Off Power Source 1 is unavailable
Green Power Source 2 is available
PWR2
Off Power source 2 is unavailable
Red Power or Port failure
Fault
Off Normal Operation
The Switch is the master of a redundant
Green
ring (X-Ring)
R.M
The Switch is not the master of a
Off
redundant ring.
LINK/ACT Green SFP Port is linked
Port 17/18* Blinking Data is being transmitted or received
SFP
Off Not connected to the network
T Green Port is linked
Port T Blinking Data is being transmitted or received
17/18* T Off Not connected to the network
RJ-45
B Green Operating at 1000M
B Off Disconnected or below 1000M
T Green Connected to the network
T Blinking Data is being transmitted or received
T Off Not connected to the network
P1-16*
B Yellow Operating in full-duplex
B Blinking Data collision
B Off Half-duplex or not connected
Ports 1 through 16 are 10/100 RJ-45, Ports 16 & 17 are
*Note
100/1000 RJ-45 or SFP.
815-433-5100 Fax 433-5104
+353 91 792444 Fax +353 91 792445 www.bb-europe.com orders@bb-europe.com support@bb-europe.com
4
o
Meaning
o
o
5
o
o
o
o
International Headquarters: 707 Dayton Road PO Box 1040 Ottawa, IL 61350 USA
www.bb-elec.com
European Headquarters: Westlink Commercial Park Oranmore Co. Galway Ireland
EIR618 Series-5107qsg

Hardware Installation

Record the switch's MAC Address in the space
provided. The MAC Address is printed on the product
label. NOTE: Provide the MAC Address to your
Network Administrator. The Network Administrator
should provide an IP Address, Subnet Mask, and
Gateway.
Select a mounting location and install with the attached
DIN rail clip or included panel mount kit.
Connect power to the switch
12 to 48 VDC
o
Redundant inputs are available with fault
o
contacts.
NOTE: The installation of an SFP Module disables
the associated RJ-45 Port.
Log into the Switch
These instructions are for Web based management.
Refer to the User's Manual for instructions concerning
console management.
Connect a switch port to a stand alone PC. Change the
PC's network IP Address to allow it to connect to the
switch (ex: 192.168.16.2). Use the default subnet mask
and gateway.
Launch the PC's web browser and navigate to the
switch by typing the switch's IP Address in the browser
address window.
Navigate the web page by expanding the folders on the
left side of the web page.
orders@bb-elec.com support@bb-elec.com