B&B Electronics Elinx EIR510 Series Quick Start Manual

Quick Start Guide
Elinx Managed Ethernet Switch
EIR510 Series
1
Items Included
Ethernet Switch
o
Console Cable (RS-232 RJ-45 to DB-9)
o
CD with Support Manual
o
This Quick Start Guide
o
Panel Mount Bracket
o
2
Default Settings
IP Address: 192.168.16.1
o
Subnet Mask: 255.255.255.0
o
Gateway: 192.168.16.254
o
User Name: root, Password: root
o
3
LED Chart
LED Status
Green The Switch is powered on
PWR
Off The Switch is powered off
Green Power Source 1 is available
PWR1
Off Power Source 1 is unavailable
Green Power Source 2 is available
PWR2
Off Power source 2 is unavailable
Orange A power or port failure has occurred
Fault
Off Normal Operation
The Switch is the master of a redundant
Green
ring (X-Ring)
R.M
The Switch is not the master of a
Off
redundant ring.
Green The port is linked
LINK/ACT
Blinking Data is being transmitted or received
(P9/P10)
Off Not connected to the network
Top Green Connected to the network
Top Blinking Transmitting or receiving
Top Off Not connected to the network
P1-8
Bottom Orange Operating at full-duplex
Bottom Blinking Collision
Bottom Off Half-duplex or not connected
4

Hardware Installation

Record the switch's MAC Address in the space
o
provided. Provide the MAC Address to your Network
Administrator. The Network Administrator will
provide an IP Address, Subnet Mask and Gateway.
Select a mounting location and install with the attached
o
DIN rail clip or included panel mount kit.
Connect power to the switch
o
24 to 48 VDC
o
Redundant inputs are available with fault
o
contacts.
815-433-5100 Fax 433-5104
+353 91 792444 Fax +353 91 792445 www.bb-europe.com orders@bb-europe.com support@bb-europe.com
5
Meaning
o
o
o
o
International Headquarters: 707 Dayton Road PO Box 1040 Ottawa, IL 61350 USA
www.bb-elec.com
European Headquarters: Westlink Commercial Park Oranmore Co. Galway Ireland
EIR510 Series-5107qsg
Log into the Switch
These instructions are for Web based management.
Refer to the User's Manual for instructions concerning
console management.
Connect a stand alone PC to a port on the switch.
Change the PC's network IP Address to allow it to
connect to the switch (ex: 192.168.16.2). Use the
default subnet mask and gateway.
Launch the PC's web browser and navigate to the
switch by typing the switch's IP address in the browser
address window.
Navigate the web page by expanding the folders on the
left side of the web page.
orders@bb-elec.com support@bb-elec.com