Pyronix STERLING 10 Installation Instructions page 2

STERLING 10
PCB Layout
Micro-
Controller NVM Terminals
Tamper
Volume Control
Switch
Keypad Layout
SYSTEM DISARMED
Not in
Use
Personal
Attack
P.A.
2 3
1
A B C
ABC
DEF GHI
Fire
4 5 6
D
JKL MNO PQR
Fire
7 8 9 0
SPACE
STU VWX YZ
Entering Engineer Mode
TM
‚ )llll
Enter
The engineer has the following keypad functions available:
Change Text
‚
Press and use the
CHANGE TEXT
'
ƒ
Use the key to scroll to the text to change is displayed.
Each key has been assigned three letters of the alphabet. By pressing
the key several times the number and letter sequence will be scrolled
through. When the desired letter or number is displayed, use the
Speaker
€
and scroll keys to move between segments on the display and
when the text is complete press the
EXIT
key to scroll to '
NOTE: The system must be in engineer mode to be able to change
the zone names.
Version Number
Contrast Control
To find the software version number and language of the keypad press
‚ ƒ
and use the
Version No.
again to display '
version and language.
Self Test
STERLING
‚
Press and use the
Arm Key
VERSION NO.
again to display '
SELF TEST
' '. Press the
ARM
display now reads '
scroll, press any key. The display now reads '
Func
Enter
After pressing all the keypad keys the fire tones at the keypad will
Function
sound. Press any key to stop the tones.The keypad test is now
Key
complete. If any faults are found during the test the keypad will
display the fault and continue with the test. If there is a bad key and
Scroll
the key test will not finish, hold down a working key to quit the test.
Keys
ƒ
key to scroll through the functions until
‚
' is displayed. Press .
‚
key to accept. Use the
‚
' and press to accept.
FUNCTIONS
key to scroll down to ' '. Press
‚
' P ress to display the software
ƒ FUNCTIONS
key to select ' '. Press
ƒ
' and press the key to display
‚
key to start the test process.The
PLEASE WAIT
'.When the display begins to
PRESS ALL KEYS
Set Backlight
To set the keypad backlight.
‚ ƒ
Press and use the key to select '
‚ ƒ
Press accept and use the
‚
backlight illumination. Press
Send Names
‚ ƒ
Enter and use the key to scroll down to '
‚ VERSION NO.
Press again to display '
SEND NAMES
scroll down to '
the keypad programmed data to other LCD keypads in the system.

Arming the Panel
ƒ
llll
Enter (User code), press
©
for the Arm Mode required.
Disarming the Panel
llll
Enter (User code)
Silent Arm
‚
‚ ¤ ¦ §
Enter , then pres either
Contrast Control
Adjust the contrast control while viewing the display until the
optimum contrast level is obtained.
‚
'.
SET BACKLIGHT
'.
„
and keys to set the required
accept.
FUNCTIONS
'.
ƒ
' Use the key to
‚
'. Press the key to start sending
 ¤ ¦ §
then either or
©
or .
RINS210-2