Ricoh DDP User Manual page 91

Message
Invalid Combination #2
Cancel Job
Invalid Folder #xx
Clear Paper Path
Invalid Folder #xx
Cancel Job
Invalid Password
Invalid Time Server Address
Invalid Value
LED Eraser Not Set
Set Erase Lamp E080
Lifting Tray Name
Loading Fail Network
Loading Network
Low on Front Staples
Low on Rear Staples
Low Toner - Recovery
E09A
MBT
Load xx E090
Network Load Failed
Open Stacker Full
Out of Front Staples
Load Staples
Out of PF Front Staples
Load Staples
Out of PF Rear Staples
Load Staples
Out of Rear Staples
Load Staples
Paper in Connecting Unit
Remove Paper E073
Paper in Duplex Path
Remove Paper E05C
Paper in Fin Holding Path
Remove Paper
Paper in Fin Sheet Path
Remove Paper
Paper in Finisher
Remove Paper E064
Description
Incorrect stacker choice requested:
(Cannot deliver to Container Stacker
from Inserter.)
The Booklet Finisher cannot perform
the operation.
The Booklet Finisher cannot perform
the operation.
A valid password is required to access
this area of the OCP.
Incorrect value in time server IP
address field.
Incorrect value entered.
The LED eraser is not set.
The specified tray is moving into the
feed position.
Status message.
Status message.
Status message.
Status message.
In process of supplying the toner.
The wrong paper size is loaded in the
multi-bypass tray.
Network connection error.
The output tray is full.
The front stapler unit of the Advanced
Finisher is out of staples.
The front stapler unit of the Publishing
Finisher is out of staples.
The rear stapler unit of the Publishing
Finisher is out of staples.
The rear stapler unit of the Advanced
Finisher is out of staples.
Paper jam in connecting unit of the
Publishing Finisher.
Paper jam on return path 1.
Paper jam in holding path.
Paper jam in sheet path.
Paper jam in entrance path of the
Advanced Finisher.
Corrective Action
Cancel the job.
Remove the remaining paper and
cancel the job.
Cancel the job.
Retry password. If incorrect, contact
your System Administrator.
Check the time server IP address via
the Web Utilities.
Re-enter value.
Contact your authorized Service
Technician.
Status message. Wait for the printer to
return to a Ready state.
Wait for the printer to return to a Ready
state.
Wait for the printer to return to a Ready
state.
Have replacement staples available.
Have replacement staples available.
Wait for the printer to return to a Ready
state.
Load the MBT with the requested
paper size.
Check the Ethernet cable of the NIC.
Remove the paper from the tray.
Replace the front staple cartridge.
Replace the front staple cartridge.
Replace the rear staple cartridge.
Replace the rear staple cartridge.
Remove the jammed paper.
Remove the jammed paper.
Remove the jammed paper.
Remove the jammed paper.
Remove the jammed paper.
Troubleshooting 5-7