Table of Contents
Advertisement
S
ETUP
3. S
ETUP
AC Power
The EVE F-50Z has an auto-ranging power supply and it can work with an input voltage range of 100 to
240 VAC, 50/60 Hz. To determine the product's power requirements (circuit breaker, power outlet, and
wiring), use the current value listed on the label affixed to the product's back panel, or refer to the product's
specifications chart. The listed current rating indicates the product's average current draw under normal
conditions.
•
Always connect the product to a protected circuit (circuit breaker or fuse).
Make sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-
use completely disconnect the product from power via breaker or by
unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.
Fuse Replacement
1.
Disconnect the product from power.
2.
Using a flat-head screwdriver, loosen the fuse holder and pull straight out.
3.
Remove the blown fuse from the holder.
4.
Replace with a fuse of the exact same type and rating.
5.
Insert the fuse holder back in place and reconnect power.
Disconnect the product from the power outlet before replacing the fuse.
Power Linking
The product provides power linking via the Edison outlet located in the back of the product. Please see the
diagram below for further explanation.
Power Linking Diagram
You can power link up to 16 EVE F-50Z products on 120 VAC or up to 26 EVE F-50Z
products on 230 VAC.
The power linking diagram corresponds to the North American version of the
product ONLY! If using the product in other markets, you must consult with the local
Chauvet distributor as power linking connectors and requirements may differ in
your country or region.
EVE F-50Z User Manual Rev. 2
st
1
Product
nd
2
Product
rd
3
Product
Additional
Products
Page 5 of 14
Advertisement
Table of Contents
