General Wiring Instructions ..................................8 Control and Harness Diagram ................................. 9-11 Trobleshooting ...................................... 12-13 Warranty ........................................14 Spreader Views Model # SP-575V ..................................15 Frame Assembly Parts Breakdown Model # SP-575V ..................................16-17 Drive Assembly Parts Breakdown Model # SP-575V ..................................18-19 Notes ........................................
RELIABILITY: High impact linear low density polyethelyne hopper. State-of-the-art electronic dual variable speed control, custom engineered powder coated frame, maximum torque 12-volt motor coupled to a custom engineered transmission; found only on SnowEx products. VERSATILITY: Multi-use capabilities allows spreading of a variety of materials for snow and ice control.
Introduction This manual has been designed for your help. It will assist you and instruct you on the proper set-up, installation and use of this spreader. Refer to the table of contents for an outline of this manual. We require that you read and understand the contents of this manual completely (especially all safety information) before attempting any procedure contained herein.
For your safety warning and information decals have been placed on this product to remind the operator of safety precautions . If anything happens to mark or destroy the decals, please request new ones from SnowEx. Remember, most accidents are preventable and caused by human error. Exercising of care and precautions...
Operating the Spreader Model # SP-575V SPREADER LOADING WARNING – Do not overload vehicle. Use chart below to calculate weight of material. Weights of material are an average for materials. Material Weight Per Cubic Ft. Rock Salt 80-90 lbs. Sand/Salt Mix 95-120 lbs.
Spreader Maintenance Model # SP-575V • WARNING – When servicing is necessary, perform it in a protected area Do not use power tools in rain or snow because of danger of electrical shock or injury. Keep area well lighted. Use proper tools. Keep the area of service clean to help avoid accidents.
It is not recommended to attach to fuel or brake lines for obvious reasons. Do not route close to exhaust system or engine, even though Snowex uses high temperature wiring, it still could melt under extreme heat and short the spreader electrical system, as well as the vehicle electrical system.
Control Diagram Model # SP-575V F50574 Control Pendant F50596 Spreader Control IMPORTANT: Do Not modify harness length. Any modifications will void warranty. Special Notes: 1) All external connections must have dielectric grease. 2) Read lead labels before attaching to power source or ground.
Neither Snowex, nor any company a liated with it, makes any warranties, representations for promise as to the performance or quality other than what is herein contained. The liability of Snowex to the purchaser for damages arising out of the manufacture, sale, delivery, use or resale of this spreader shall be limited to and shall not exceed the costs of repair or replacement of defective parts.
Need help?
Do you have a question about the SP-575V and is the answer not in the manual?
Questions and answers