SnowEx products. Here’s why… SIMPLICITY: Fewer moving parts manufactured of higher quality means minimal maintenance for your SnowEx spreader. RELIABILITY: High impact linear low density polyethelyne hopper. Custom engineered, powder coated frame. And a custom engineered trans- mission found only on Snowex products.
Introduction This manual has been designed for your help. It will assist you and instruct you on the proper set-up, installation and use of this spreader. Refer to the table of contents for an outline of this manual. We require that you read and understand the contents of this manual completely (especially all safety information) before attempting any procedure contained herein.
Safety Before attempting any procedure in this book, these safety instructions must be read and understood by all workers who have any part in the preparation or use of this equipment. For your safety warning and information decals have been placed on this product to remind the operator of safety precautions . If anything happens to mark or destroy the decals, please request new ones from TurfEx.
Assembly Instructions Model # SP-85 / SP-85SS Step 1: Slide Actuator Rod up through the slot in the Spreader Support Leg from the spinner side. Step 2: A: Attach Actuator Rod to Gate Linkage. Secure with Hair Pin Clip. B: Remove Pivot Bolt that attaches the Gate Linkage to Frame.
Assembly Instructions Model # SP-85 / SP-85SS Step 3: A: Attach Actuator Rod to Handle. B: Slide Handle Assembly onto Spreader Frame and install corresponding Hardware from provided Hardware Kit. C: Reinstall Pivot Bolt that was removed in Step 2B.
Operating the Spreader Model # SP-85 / SP-85SS SPREADER LOADING Capacity: 2 Cubic Ft Hopper WARNING – Do not overload spreader. Weights of material are an average for dry materials. Material Weight Per Cubic Ft. Bulk Salt 80-90 lbs. •...
Troubleshooting Model # SP-85 / SP-85SS DROP SPREADER: TOO MUCH GATE STUCK OPEN LUBRICATE GATE SLIDES ADJUST FRONT GATE MATERIAL FLOW SLIDE ADJUST GATE STOP LUBRICATE LINKAGE REMOVE AND CLEAN IF BROKEN, REPLACE CABLE STUCK LUBRICATE REPLACE RECONNECT ACTUATOR / LINKAGE...
Neither SnowEx, nor any company affiliated with it, makes any warranties, representations for promise as to the performance or quality other than what is herein contained. The liability of SnowEx to the purchaser for damages arising out of the manufacture, sale, delivery, use or resale of this spreader shall be limited to and shall not exceed the costs of repair or replacement of defective parts.
Need help?
Do you have a question about the SP-85 and is the answer not in the manual?
Questions and answers