Change Engine Oil; Change Engine Oil & Filter - Allis-Chalmers AC-130 Series Operator's Manual

Hydro tractor and mower deck
Hide thumbs Also See for AC-130 Series:
Table of Contents

Advertisement

Available languages

Available languages

Change Engine Oil

Service Interval: 50 hours or once per season.
Oil Capacity: Approximately 1-7/8 quarts (1.8 L) without
filter change.
NOTE: Change engine oil while the engine is warm. Run
the engine for a few minutes, then shut the engine off
and allow it to cool from hot to warm.
1. Clean the area around the dip stick (C, Figure 22)
and oil drain valve (A).
2. Drain engine oil. See "Oil Drain Valve Operation"
above.
3. Fill the crankcase with oil. See "Check Engine Oil
Level."
Change Engine Oil & Filter
Service Interval: 100 hours or once per season.
Oil Capacity: Approximately 2 quarts (1.9 L) with oil filter
change.
NOTE: Change engine oil while the engine is warm. Run
the engine for a few minutes, then shut the engine off
and allow it to cool from hot to warm.
1. Clean the area around the dip stick (C, Figure 22)
and oil drain valve (A).
2. Drain engine oil. See "Oil Drain Valve Operation"
above.
3. Remove the oil filter (B). Discard the filter.
4. Using a drop of oil on your finger tip, wet the rubber
gasket on the bottom of the new filter.
5. Turn the filter clockwise until the rubber gasket meets
the filter base. Then turn 1/2 to 3/4 turn more.
6. Fill the crankcase with oil. See "Check Engine Oil
Level."
7. Test run the engine to check for leaks. Stop the
engine for 1 minute, then recheck the oil level.
Use oil classified API Service Class SF,
SG, SH, SJ or better with SAE Viscosity:
5W-30
10W-30
Conventional*
Synthetic 5W-30, 10W-30
˚F
-20
0
20
-30
-18
-7
˚C
*CAUTION: Air cooled engines run hotter than automotive engines.
The use of non-synthetic multi-viscosity oils (5W-30, 10W-30, etc.)
in temperatures above 40º F (4ºC) will result in higher than normal
oil consumption. When using a multi-viscosity oil, check oil level
more frequently.
**CAUTION: SAE 30 oil, if used below 40º F (4ºC), will result in hard
starting and possible engine bore damage due to inadequate
lubrication.
Figure 24. Recommended Engine Oil
25
Regular Maintenance
30 Conventional**
40
60
80
100
32
4
16
27
38
0

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2690812269081316956021695603

Table of Contents