70
Change parameter
by pressing
SAVE
If you want to monitor actual values during the ID Run, go to
the Output mode by pressing
there.
Press
to start the ID Run. The panel keeps switching
between the display that was shown when you started the ID
Run and the alarm display presented on the right.
In general, it is recommended not to press any control panel
keys during the ID Run. However, you can stop the ID Run at
any time by pressing
After the ID Run is completed, the alarm display is not shown
any more.
If the ID Run fails, the fault display presented on the right is
shown.
Change parameter
by pressing
If you want to monitor actual values during the ID Run, go to
the Output mode by pressing
there.
Press
to start the ID Run. The panel keeps switching
between the display that was shown when you started the ID
Run and the alarm display presented on the right.
In general, it is recommended not to press any control panel
keys during the ID Run. However, you can stop the ID Run at
any time by pressing
After the ID Run is completed, the alarm display is not shown
any more.
If the ID Run fails, the fault display presented on the right is
shown.
Start-up, control with I/O and ID Run
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
ID RUN WITH THE ASSISTANT CONTROL PANEL
to 1 (
ID RUN
ON
9910
.
repeatedly until you get
EXIT
.
ID RUN WITH THE BASIC CONTROL PANEL
to 1 (
ID RUN
ON
9910
.
repeatedly until you get
.
). Save the new setting
). Save the new setting
ACS550-02/U2 User's Manual
LOC
PAR EDIT
9910 ID RUN
ON
[1]
CANCEL
00:00
SAVE
LOC
50.0Hz
0.
0 Hz
0.
0 A
0.
0 %
DIR
00:00
MENU
LOC
ALARM
ALARM 2019
ID run
00:00
LOC
FAULT
FAULT 11
ID RUN FAIL
00:00
9910
LOC
PAR
FWD
1
LOC
PAR
SET
FWD
00
LOC
.
OUTPUT
FWD
A2019
LOC
FWD
F0011
LOC
FWD
Hz