The Coil Menu - AKA Berkut 5 Operating Instructions Manual

THE COIL MENU

In the menu COILS the following parameters are available:
COILS-Defines the coil currently installed on the device. The type of coil needs to
exactly match the currently installed coil (size and frequency). More detailed
description of this procedure is outlined in the section on replacing search coils.
EDITOR – Accesses the coil editor parameters. To access the editor press + button. The
following options will appear (a Fig. 29) :
Currently selected coil ( ie D6x10-7)
 On/off of including the currently selected in added coils( previously
compensated)
 Auto –initiates Auto inclusion of the currently selected coil.
 Manual adjustment of the working frequency of the detector (Should
correspond to the working frequency of the installed coil)
 Manual adjustment of a basic signal of synchronous detector
 Manual adjustment of an initial phase of ground balance
COILS
Coil:
Editor
Fig. 28
D6x10-7
On
Auto
Fr = 06725
Ort = 095
Ph = 018
Fig. 29
D6x10-14
1