Overload Mode; User Programs - AKA Berkut 5 Operating Instructions Manual

To quickly set the special signal to a certain class of objects you may use the fast
teach mode. Insure that teach mode is set to on. Insure device is in discriminate mode (D).
Scan the desired target insuring an accurate and repeatable VDI.
To include the scanned target in the special signal press the
the operation press [PR/MENU] .
Any object whose VDI falls within this sector will generate the bell tone.

OVERLOAD MODE

AT times you will encounter large shallow objects that can overload the detectors
electronics. Under this overload condition the detector cannot properly identify the object.
When this happens a warning message will be displayed and an audible warning will be
heard. The volume of which is set under parameter OVERLOAD VOLUME (page 23).
If the overload warning occurs too often it is recommended to reduce the
sensitivity of the device by means of parameters gain and/or coil current (p. 17, 18) or to lift
the gauge above over a ground. If the overload arises on single instances simply raise the
coil and re scan the object.
There can be situations where an overload occurs yet no target can be located.
This is usually due to an elevated level of mineralization in the ground. In this case it is
necessary to reduce sensitivity.

USER PROGRAMS

The detector has been programmed with 4 user programs. These programs are fully
able to be edited by the user to suit their own preferences. Switching between programs is
carried out by short term pressing of the [PR/MENU] button. In the bottom left hand
corner of the display is the number of the currently selected program.
Any change of a parameter is automatically stored in memory for the current
program. Remember the detector can be restored to the default factory settings at any
time. To perform the factory resets turn the detector off. Press and hold the [PR/MENU]
button while turning the detector on. Once the detector has turned on a message will be
displayed indicating factory settings have been restored. The Menu button can now be
35
S K M An
A
OVERLOAD
T
3
TURBO
Fig. 33
button. To cancel