Table of Contents
Advertisement
ADJUSTING THE NEW COIL TO THE
CURRENT PROFILE
If, while in use, it was necessary to make repeated adjustments to the coil, or you
do not wish to use different profiles for different coils, and prefer to make adjustment at
each switching of gauges (similar to some of our other models), take advantage of a mode
of adjustment of the new coil under the current profile. This mode can be activated in
several ways:
By means of the basic menu of the device (Coils - Editor - Auto)
By means of the inclusion menu (Power on while depressing [Fn] -
To adjust the coil)
By means of fast accessing the main menu (Powering on while holding button [+])
For adjusting the new coil for the current profile:
Turn off the detector
Connect the coil to the device
Activate one of the modes described above
After the automatic adjustment of the frequency and ORT, the device switches to
Ground Balance
Perform the Ground Balance procedure on pure ground, ferrite or a piece of red
brick.
If the GB value differs from zero significantly then press the button [
To exit from the adjustment mode press the button [GB]
Switch the device off and then back on.
Recheck the operation of the detector on several typically found objects.
ADDITION OF A NEW COIL TO A NEW PROFILE
If you have purchased a new coil whose size or operating frequency is different
from a previously established coil then it is necessary to use the mode addition of the new
coil. It can be performed in two ways:
By means of the basic menu of the detector (Coils - Editor)
By means of the inclusion menu
To add the gauge)
For addition of the new gauge to a new profile, it is necessary to perform the
following:
Turn off the detector
Connect the coil to the device
Activate a mode one of specified above ways
Choose the profile name, corresponding to the parameters of the new coils
(size and frequency)
Activate an adjustment mode
If you are using the main menu method then move the cursor to AUTO and
press [+]
40
(Power on while depressing the button [Fn]-
] to zero.
Advertisement
Table of Contents
