Adding Covers - Ricoh MP 4002 Quick Start Manual

There are two steps to adding covers to a document. First, you must define the type of paper being used for the Cover in
User Tools, and next, you have to select the cover during the copy process. Both procedures are shown below.
1. In User Tools, select [System Settings]. 2. Select the [Tray Paper settings] tab,
4. Select Cardstock as the paper type,
and select the paper thickness of your
cover stock. For this example, we chose
Thick Paper 1. Then, select [OK].
8. While copying, select [Cover/Slip
Sheet].

Adding Covers

and then [Next] to go to page 2.
5. To get to the next setting, select
[Next].
7. Select [Bypass Tray] to define the
Bypass Tray as the one with the cover
stock. Then, select [OK], and [Exit] User
Tools.
9. Depending upon whether or not you
want to copy onto the cover, you can
select [Copy] or [Blank].
Page 18
3. Select the [Paper Type: Bypass Tray]
button (if that's where your cover stock
is loaded).
6. On page 3, select [Cover Sheet Tray].
9. For our example, we are copying
onto both front and back covers, so we
selected [Front/Back Cover Copy].