Ricoh Aficio 3030 Operating Instructions Manual page 156

Appendix
Messages/Second messages
IEEE 802.11b (Wireless LAN)
has a problem.
Paper in staple tray. Open
Finisher Cover and remove
paper.
Parallel I/F board has a prob-
lem.
Printer font error.
Memory Overflow
DToner is almost empty.
8
USB has a problem.
150
Causes
IEEE 802.11b interface unit
was not inserted when the ma-
chine was turned on, or it was
pulled out after the machine
turned on.
The settings are not updated
although the unit is detected,
or errors are found while ac-
cessing the unit.
There is paper remaining in-
side the finisher.
An error has occurred in the
parallel interface board.
An error has occurred in the
font settings.
Maximum capacity of PCL or
PostScript 3 list display has
been exceeded.
The toner has almost run out.
An error has occurred in the
USB interface.
Solutions
Turn off the machine and
check the IEEE 802.11b inter-
face unit is inserted correctly.
Then, turn the machine on
again. If the message appears
again, call your service center.
Open the cover of the finisher,
and remove the paper.
Contact your sales or service
representative.
Check the font settings.
Reduce the value of [Resolu-
tion:] in the printer driver. Al-
ternatively, select [Frame
Priority] from [Memory Usage] in
[System] (see p.128 "System").
If this message continues to
appear after taking these
steps, decrease the number of
files sent to the machine.
Replace the toner cartridge
with a new one.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.