TP-Link EAP320 Quick Installation Manual page 2

Option 1: Ceiling Rail Mounting
Ceiling T-rail Clip M3×6 Pan-head Screws
(Qty.5)
1
Position the Ceiling T-rail Clip and push the movable
part toward the rail base.
2
Use an M3×6 pan-head screw to secure the T-rail Clip
onto the ceiling rail.
3
Attach the mounting bracket to the Ceiling T-rail Clip
using four M3x6 pan-head screws.
4
Make the Ethernet Cable pass through the fixing hole
of the mounting bracket. Connect the cable to the
ETHERNET port and attach the EAP to the bracket.
5
Push the EAP along the direction of arrows until it
locks into place, as shown on the left. Then adjust
the cable to make the exposed part hidden behind
the EAP.
Website: http://www.tp-link.com Tel: +86 755 26504400
Option 2: Ceiling Mounting
Hole for Ethernet cable
E-mail: support@tp-link.com
Washers M3×30 Pan-head Screws Wing Nuts
(Qty.4) (Qty.4)
(Qty.4)
1
Remove the ceiling tile.
X4
2
Place the mounting bracket in the center of the ceiling
tile. Mark the four positions of the screw holes and a
hole for the Ethernet cable to feed through.
Drill four 4mm holes for the screws and a 10mm hole
for the Ethernet cable.
3
Secure the mounting bracket to the ceiling tile using
four M3x30 pan-head screws, washers and wing
nuts.
4
Feed the Ethernet cable through the hole. Then set
the ceiling tile back into place.
5
Connect the Ethernet cable to the ETHERNET port
and push the EAP along the direction of arrows until it
locks into place, as shown on the left. Then adjust the
cable to make the exposed part hidden behind the
EAP.
Option 3: Wall Mounting
Note: We do not recommend you to install the EAP with the Ethernet port upward.
M3×28 Plastic Wall Anchors M3×20 Self-tapping Screws
(Qty.4) (Qty.4)
X4
1
If your Ethernet cable feeds through the wall, you can
position the mounting bracket to make the cable
through the fixing hole. Mark the four positions of the
screw holes and then drill four 6mm holes.
2
Insert the plastic wall anchors into the 6mm holes.
3
Secure the mounting bracket to the wall by driving the
self-tapping screws into the anchors. Make sure that
the shoulders of the mounting bracket are on the
outside.
4
Connect the Ethernet cable to the ETHERNET port on
the EAP and attach the EAP to the mounting bracket,
as shown on the left.
5
Push the EAP along the direction of arrows until it
locks into place, and then adjust the cable to make
the exposed part hidden behind the EAP.
Copyright © 2016 TP-LINK