Table of Contents
Advertisement
Sending Scan Files by Scan to Folder
Note
❒ For details about the maxi-
mum number of characters
that can be entered, see p.118
"Scan to Folder".
❒ The following is an example
of a path where the folder
name is "user" and the sub-
folder name is "lib": user\lib
H Press [OK].
3
I If entering a user name to log
on is required, press [Manual In-
put] on the right side of the user
name field.
The soft keyboard appears.
J Enter the user name.
Reference
For details about the maxi-
mum number of characters
that can be entered, see p.118
"Scan to Folder".
K Press [OK].
L If entering a password to log
on is required, press [Manual In-
put] for [Password].
The soft keyboard appears.
M Enter the password.
N Press [OK].
O To change the port number
which is set in [System Settings],
press [Change] on the right side
of the port number field. Enter
a p o r t n u m b e r u s i n g t h e
number keys, and then press
the { { { { #} } } } key.
36
P Press [Connection Test].
A connection test is performed
to check whether the specified
shared folder exists.
Note
❒ The connection test may take
time.
❒ You may not be able to press
[Connection Test] right after
pressing [Cancel] during a
connection test.
Q Check the connection test re-
sult, and then press [Exit].
R Press [OK].
S To enter more destinations, re-
peat steps A A A A to R R R R .
Note
❒ To deselect a destination, press
[U U U U Prev.] or [T T T T Next] to display
the destination in the desti-
nation field, and then press
the { { { { Clear/Stop} } } } key.
❒ To change the path for the
folder that has been entered,
press [Change] on the left side
of the destination field. Enter
the correct path for the fold-
er, and then press [OK].
❒ To check the selected desti-
nations, press the { { { { Check
Modes} } } } key.
Advertisement
Table of Contents
