Specifications - FibroLAN FEM4 User And Installation Manual

Advanced FE/E1 Fiber Converters

15 - Specifications

Standard Compliance
IEE 802.3/802.3u, 10Base-T, 100Base-TX, 100Base-FX, FDSE
Far End Fault (FEF) support
IEEE 802.3x FDX Flow Control and HDX backpressure flow control
Frame length range: 64 ÷ 1916 bytes max; Supports 1K Mac addresses
LAN or Aggregation (VLAN) mode of operation
10/100BaseTX port x 4
• Shielded RJ-45 connector
• Speed and Half/full duplex support via auto-negotiation (default for all TP ports)
• Port 1 can be forced to 10/FDX, 10/HDX, 100/FDX or 100/HDX
via DIP switches S7, S8, S9
• 100m over STP Cat 5 cabling
MDI/MDI-X Auto-Cross support
•
100Base-FX port
• 1310nm multi-mode, Duplex SC 62.5/125 fiber, Full Duplex
• Single Mode Fiber: Duplex SC connector
• Single Fiber – Strand: Single SC connector
Refer to F/O port specifications (section 9)
Diagnostics: 19 LEDs
• Link, Activity (Tx or Rx), 100Base-FX port
• Link, Activity (Tx or Rx), FDX, 100M for each TP port
• Local, Remote, LOS for E1 port (FEM models)
• LOS and Signal LEDs for each E1 port (FEM4 models)
• LAN mode or Aggregation (VLAN) mode (FEM models)
• Link Partner
• Power: power on / off
24