F/O Connection - FibroLAN FEM4 User And Installation Manual

Advanced FE/E1 Fiber Converters
10 – Fiber Optic Connection
The FEM is equipped with 1 pair of SC-type connector or single SC connector for SFS
(Single –Fiber – Strand) model.
Do not remove the protective covers on the fiber connectors until you are ready to
connect the fiber optic cables. Power should be connected before attaching the fiber
optic cables. When dealing with fiber optic cables, it is essential to ensure that the TX
at one end of the link is connected to the RX at the other end of the link.
Some duplex fiber optic cables are color coded to help monitor the direction of data
transmission. If the fibers are not coded, special attention must be paid to ensure a
proper connection.
Laser Warning
CAUTION
Radiation emitted from a fiber optic connector may be hazardous
to human vision. Therefore, the following rules must be strictly
observed
All Single-mode (SM) models are CLASS I LASER PRODUCT that
may endanger your eyes and must be handled with special care
When not in use, keep the fiber optic connector closed using its
protective cover
Never stare directly into the fiber optic connector of a powered
device or into the end of a fiber connected to it.
Do not look directly into the fiber optic cables or transmitter
Laser Safety
The emissions produced by the end products described in this guide are under Class 1
emission level according to IEC 60825-1 and the FDA 21 CFR 1040.10 and 1040.1. These
products shall not be installed in an optical network handling above Class 1 level.
18