Disassembly Output Shaft (Mnt-R-0042) - RHINO SE42 Operator's Manual

DISASSEMBLY OUTPUT SHAFT (Mnt-R-0042)

1. Install slotted nut (Ref 18, Mnt-R-0040) onto shaft and then tap shaft end on solid surface to remove lower
bearing and spacer.
2. Remove snap ring (Ref #7) and then repeat above procedure to remove upper bearing.
ASSEMBLY
1. Assembly of output shaft is accomplished in exact reverse order. Install bearing over shaft and press up
against bottom end of gear. Install snap ring (Ref. #7 Mnt-R-0040).
2. Install spacer and lower bearing on shaft. NOTE: Bearing Spacer (Ref #6) may be two different lengths
and each spacer requires a different bottom cap.
LOWER BEARING RETAINER CAP (Mnt-R-0043)
1. Remove old seal from cap and press in new seal. (See SEAL INSTALLATION RECOMMENDATIONS).
Note difference between bearing caps shown to make sure proper part is being used.
SE42 03/08
© 2008 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-10