Yamaha EF4500iSE Installation And Operation Manual page 3

f
1
1
1
g
UP
5
3. Remove four screws and remove the meter unit c.
cC
c
To avoid parts becoming damaged by static electricity,
discharge the electricity from your body by touching the
engine or other metal surface before servicing the meter
unit.
4. Disconnect the engine switch coupler d.
d
e
e ..... engine switch
5. Return the harness of receiver unit 1 , and secure the
harness using band 2 .
6. Remove grommet f temporarily, and pass the receiver
f
unit harness through the grommet.
2
7. After passing the harness through the hole where the
f
grommet f has been installed, install the receiver unit 1
by screws 3 . Install the grommet f in its original position.
cC
Make sure that grommet f is secured to its original
position.
3
8. Remove cap g from the control panel, and attach switch
4
label 4 to the panel.
NOTE:
Remove cap g by pressing its top and bottom hooks and by
pulling the cap outward.
9. Install remote control switch 5 by facing its terminal
downward.
10. Connect the coupler of wire harness 6 to the coupler of
receiver unit (2 couplers), engine switch (2 couplers), and
6
remote control switch (1 coupler).
to receiver unit
(4P)
6
white tape
to receiver unit
(6P)
to engine switch coupler
(wire harness end)
to engine switch
to remote control switch
3
page