Nortek GoControl GC-DBC-1 Installation Instructions

GC-DBC-1
Installation Instructions
Install Overview
CHIME BOX
16 VAC TRANSFORMER
BLACK WIRE: TRANSFORMER WIRE
RED WIRE: CHIME BOX WIRE
4
Mounting Doorbell Camera Plate
• Use mounting plate as guide to mark holes.
• Use leveling tool to align mounting plate.
SCREWS ONLY SCREWS & ANCHORS
UP
UP
UP
OR
USE 1/4" (6.35mm) DRILL FOR
ANCHOR HOLES
MOUNTING
PLATE
System Description
CHIME BOX
SMART
DOORBELL
CAMERA
CLOUD
DOORBELL
TRANSFORMER
WiFi COMMUNICATIONS
1
Prepare for Installation
VERIFY WiFi STRENGTH
• Go to existing doorbell location.
• Use a Smartphone connected to the installations WiFi
router to confi rm adequate signal strength
VERIFY POWER SUPPLY
• The Doorbell camera works best with a 15 to 20 Volt
AC, 15 to 40 VA (Watts) supply.
• Visually inspect the doorbell transformer for power
rating (VA or Watts) and Voltage.
• Measure the doorbell wiring at the installation location
with a AC Volt meter.
5
Wiring Doorbell Camera
• Connect doorbell wires using weather-resistant wire
connectors (included).
1. TWIST THEN 2
CRIMP WIRES
.
FEED WIRES INTO
WITH PLIERS ON
SHORT END OF SHORT END OF
CONNECTOR CONNECTOR
CONNECTORS
IN PLACE
Doorbell Camera Components
SMART
DOORBELL
CAMERA
ANCHORS
(3)
PHILLIPS SCREWS
(3)
SMARTPHONE
WIRE
TORX SCREW
CONNECTORS (4)
TORX
WRENCH
2
Installing Diode in Chime Box
✔ NOTE: It is recommended to TURN POWER OFF
before performing any wiring.
1 OPEN CHIME BOX 2 INSTALL DIODE AS SHOWN
DIODE
(CATHODE
ON FRONT
TERMINAL)
IMPORTANT STEP
REAR TRANS FRONT
CHIME BOX FRONT VIEW WITHOUT COVER
✔ NOTE: Doorbell Camera is not compatible with
electronic chimes
6
Camera Installation to Mounting Plate
PUSH EXTRA WIRE INTO HANG DOORBELL CAMERA ON
MOUNTING PLATE SLOT MOUNTING PLATE TAB TOPS
Tools For Installation
SMART DOORBELL
CAMERA MOUNTING
PLATE
WIRE STRIPPERS / CUTTER
PLIERS
DIODES FOR
CHIME BOX (2)
POWER DRILL WITH 1/4" BIT
3
Existing Doorbell Removal
• Remove existing doorbell pushbutton from location.
• Disconnect wires from back of pushbutton.
REAR TRANS FRONT
Wiring Camera WITHOUT Chime
BLACK WIRE: TRANSFORMER WIRE
RED WIRE: TO DIODE
SLIDE DOORBELL
CAMERA "DOWN"
SMART
DOORBELL
CAMERA
RED WIRE
PHILLIPS SCREWDRIVER
FLAT SCREWDRIVER
LEVEL
OPTIONAL
0-M
10
0.5 50
50 200
250
- 500 +
10 600
50 250
AC VOLT METER
(OPTIONAL)
16 VAC TRANSFORMER
BLACK WIRE
DIODE