Nortek M360PIRZ Installation & Operation Manual

Wireless pir motion sensor

Table of Contents

Download this manual

Enlarged version

Federal Communications Commission Statement

This equipment has been followed to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try and

correct the interferene by one of the following measures:

Reorient or relocate the receiving antenna,

Increase the separation between the equipment and receiver,

Connect the equipment into and outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undersired

FCC Caution: Any changes or modifications not expressly approved by the party

responsible for compliance could void the user's authority to operate this equipment.

Installation & Operation Manual

M360PIRZ-1

Wireless PIR Motion Sensor

Table of Contents

Do you have a question about the M360PIRZ and is the answer not in the manual?

Page 1 FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. M360PIRZ-1 Wireless PIR Motion Sensor...
Page 2 M360PIRZ-1 Frequency Range: send the signal out when temperature changed. When the device is secure included into Adhesive tape for sensor 908.42MHz (M360PIRZ-1) Z-Wave network, above communication will be encrypted. AAA Alkaline Battery Product Description and Specification Installation & Operation Manual Operating Range: Up to 100 feet line of sight Operating Temp.: -10°C~ 40°C (5°F~104°F)
Page 3 M360PIRZ-1 on the location which can detect the room widely. 2. Walk in front of M360PIRZ-1, sensor will send Basic set On (0xFF) , Red LED willl flash once and please refer to status report as table below.
Page 4 Table 1 (Parameter 5) will send Basic Set OFF (0x00), Red LED will flash once, and refer to table for status. 4. The M360PIRZ-1 sensor equipped with tamper switch. If the tamper switch is triggered (or remove the cover), the M360PIRZ-1 sensor will send Alarm Report, LED will flash once and refer to table for status.