Operating instructions Automatic detergent dispensing unit AWD 10 en - GB To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. M.-Nr. 07 940 510...
Caring for the environment Disposal of the packing Disposing of your old materials appliance The transport and protective packing Electrical and electronic appliances has been selected from materials which often contain materials which, if are environmentally friendly for disposal handled or disposed of incorrectly and should be recycled.
Correct application recognising the dangers of misuse. The detergent dispensing unit may Technical safety only be used with a suitable Miele washing machine. Only use the unit to Before setting up the detergent dispense detergent designed for dispensing unit, check it for any domestic use and for washing fabrics.
– the connection cable with plug connector has been disconnected Accessory parts may only be fitted from the rear of the washing when expressly approved by Miele. If machine. other parts are used, guarantee, performance and product liability The Miele "Water protection system"...
General view Front view Rear view a Suds solution drainage connection a Base (detergent dissolved in water) b Indicator lights b Connection cable with plug Left: Powder detergent dispensing is connector (socket for the plug activated connector is located at the rear of the washing machine) Middle: In-operation indicator c Water inlet connection...
Installation and connection Positioning the detergent It can be located in a variety of positions. dispensing unit For safety reasons the dispensing unit must not be positioned above sockets, switches, lights and other electrical appliances. The unit must be easily accessible for refilling.
Installation and connection Positioning guide – To screw the guide in place The positioning guide is used to position the detergent dispensing unit securely on the lid of the washing machine. It prevents the unit from moving about during spinning. The positioning guide must be screwed in place if the washing machine is installed on a plinth or on...
Installation and connection Connecting the hoses Connecting the hoses to the washing machine ^ Note the diameter at the end of the hoses, to ensure you insert the correct hose to the washing machine. Tip to make fitting easier: Moisten the hose seals with water or suds solution ^ Take the 6 screws out of the bag.
Installation and connection Attaching the plug connector The connection socket for the plug connector is located at the rear of the washing machine. The hoses can be connected at an angle to suit the installation. Tip to make fitting easier: Moisten the hose seals with water or suds solution ^ Lift up the retainer and pull the cap beforehand.
Before using for the first time Adding detergent Make sure that you fill each container with the correct type of detergent. d = Liquid detergent ^ Open the lid of the container. ^ Fill the container with liquid detergent up to the maximum level mark. Tip: ^ Place the containers on the base.
Cleaning and care Cleaning the liquid detergent container d Do not use solvents, abrasive cleaners, glass cleaners or multi-purpose cleaning agents. Clean the container every six months These might damage plastic or each time you change brand of surfaces and other components liquid detergent.
Cleaning and care ^ Rinse the valve unter hot, running water. ^ Rinse the container with hot water to remove any detergent residues. ^ Clean the container with a mild non-abrasive cleaning agent or soap and water using a well wrung-out cloth.
Cleaning and care Cleaning the powder detergent container c Cleaning the dosing cog If left standing for a long time, powder detergent can clump together in the dosing cog. Check the cog regularly and clean it once a month. ^ Remove the lid. ^ Use a screwdriver to undo the two screws in the lid of the detergent compartment and lift off the lid.
Cleaning and care ^ If necessary, use the coupling to turn Cleaning the container and agitator the agitator a bit further. Clean the container and agitator every six months. ^ Remove the lid. ^ Pour any remaining powder detergent into another container to keep it for future use.
Cleaning and care ^ Rinse the container with hot water to remove any detergent residues. Danger of injury. Do not use force or sharp utensils to remove hardened detergent residues from the agitator. ^ Soak the agitator in hot water to soften hardened residues.
Problem solving guide No detergent or only a little detergent is dispensed. Problem Possible cause Remedy The in-operation light The detergent Check the connection at the does not light up after dispensing unit plug rear of the washing machine. the washing machine connector is not has been switched on.
Problem solving guide Not enough detergent The dosage level has – Increase the dosage level was dispensed. been set too low. and select a higher degree of soiling setting, if necessary. – How to set the dosage level is described in the "Auto- matic detergent dispensing"...
Problem solving guide White residues which The powder detergent – Try and brush off the look like powder contained compounds residues with a soft brush detergent are seen on (zeolites) to aid water once the laundry is dry. dark textiles after softening which are not –...