Iiyama ProLite LE7540UHS User Manual page 33

Confi guration1
Adjustment Item
Switch on state
Panel saving
RS232-routing
2,3
Boot on source*
WOL
RGB range
1
* Only VGA and HDMI input.
2
* No failover function, system will keep source even the source is no signal input.
3
* Press to display the options.
4
* It can be used only when OPS is installed.
Picture Switch on state
Screen Panel saving
Audio RS232 routing
Configuration1 Boot on source
Configuration2
WOL
Advanced option RGB range
Configuration1 reset
Factory reset
Problem / Option
The display will remain off when the power cord is
Power off
connected to a wall outlet.
The display will turn on when the power cord is
Forced on
connected to a wall outlet.
The display will return to the previous power status (on/
off /standby) when removing and replacing the power
Last status
cord.
Off
Brightness
On
For the display to slightly expand the image size and
shift the position of pixels in four directions (up, down,
left or right).
Off
1
Pixel shift*
Auto
0-80
Select the network control port.
RS232 / LAN RS232 / OPS RS232*
When the power is turned on, it starts with the same
Last input setting as when the power was last turned off .
Disable / Enable
Select input source when boot up.
Input HDMI1 / HDMI2 / HDMI3 / HDMI4 / DisplayPort / VGA /
4
OPS*
Select playlist index for Mediaplayer, Browser and PDF
Playlist
player.
WOL is turned off .
Off
On Turn the display on remotely over LAN network.
Auto
Set color scale signal automatically.
Full range For full-range color scale signal.
Limited range For limited color scale signal.
Force on
Action
RS232
Action
Off
Auto
Action
Action
Brightness is turned off .
The image brightness will be reduced to an
appropriate level.
Pixel shift is turned off .
Move the position of the image
automatically.
Move the position of the image at set
intervals.
4
/ Mediaplayer / Browser / CMS / PDF player / Custom
Button to Press
OPERATING THE DISPLAY 29