Advertisement
KIT PREPARATION
1. Remove (2) white plastic retaining clips from top brackets on factory pocket/panel.
2. Remove (2) screw brackets from bottom of factory pocket/panel.
3. Attach (2) white plastic retaining clips to the top brackets on the Scosche kit panel. See Illustration A.
4. Insert (2) screw brackets into openings in Scosche kit panel. See Illustration B.
ILLUSTRATION A
Get top quality Scosche car audio products on our website.
ILLUSTRATION B
2
POCKET ASSEMBLY
A. ATTACHING THE REAR BRACKET:
Align the two (2) screw emboss locations to the matching locations on pocket. When aligned, slide
the bracket together. Screw the two (2) supplied screws to screw emboss locations
B. ATTACHING THE POCKET:
Align the pocket to the snaps of kit panel. Snap the pocket into place on the back of kit panel.
STEREO INSTALLATION
TO REMOVE POCKET BELOW FACTORY RADIO
1. Gently pry up to remove shift trim bezel.
2. Open ashtray/small storage pocket. Remove pocket. Extract two screws from pocket opening.
Unplug and remove assembly.
3. Extract two screws from lower part of large dash storage pocket. With pocket door closed pull
toward shifter to unsnap clips and remove.
4. Extract two 8mm bolts from under radio assembly brackets.
CONTINUE TO REMOVE FACTORY RADIO
5. From above radio assembly gently pry out on vent/hazard panel. Continue along both sides of
panel, gently releasing clips. Lift up, unplug, and remove.
6. Extract three screws from top of radio assembly. Pull toward shifter to unsnap clips. Unplug and
remove.
5452
MOUNTING KIT PANEL
5125 POCKET
5324 REAR
SUPPORT BRACKET
3
Advertisement
